230V Thermostat XH-W3001 E6113

230V Thermostat XH-W3001 E6113
2. 230V Thermostat XH-W3001 E6113
3. 230V Thermostat XH-W3001 E6113
4. 230V Thermostat XH-W3001 E6113
5. 230V Thermostat XH-W3001 E6113

230V Thermostat XH-W3001 E6113

PRICE: 4,99 €
BUY NOW
IN A WAREHOUSE above 10 pcs
We'll ship this product in 3 days.
FREE EUROPE SHIPPING FROM 149 €! 30 DAYS FOR A RETURN!
Sign up and unlock up to 10% off!
JOYs

ELECTRONIC TEMPERATURE CONTROLLER THERMOSTAT 230V XH-W3001 AC110-230V W3001

The W3001 temperature controller enables the control of various electrical devices such as central-heating pumps, water pumps, circulation pumps, etc.

A simple and reliable system for temperature control. The controller can operate in both "cooling" and "heating" modes, making it a highly versatile device.
Technical data:

Input voltage (power supply): AC 110-230V
Temperature measurement range: -50°C - +110°C
Maximum relay load: 1500W
Temperature measurement resolution: 0,1°C (up to 99,9°C)
Temperature refresh rate: 0,5s
Sensor used: NTC10K
Temperature measurement probe: waterproof
Length of cable with probe: 100cm
Length of the remaining cables: 8-10cm
Display: 3-digit LED
Display colour: red
Housing dimensions without mounts: 60 x 45 x 31 mm
Mounting hole spacing: 73 mm

Programming:

Setting the temperature at which the device connected to the controller is switched on (start):

Press and hold the ^ button for 3 seconds to start the temperature editing mode – the display should start flashing. In editing mode, the desired temperature can be set using the ^ and ˇ buttons. After setting the temperature, do not touch any buttons for 3 seconds so that the set temperature is saved.

Setting the temperature at which the device connected to the controller is switched off (stop):

Press and hold the ˇ button for 3 seconds to start the temperature editing mode – the display should start flashing. In editing mode, the desired temperature can be set using the ^ and ˇ buttons. After setting the temperature, do not touch any buttons for 3 seconds so that the set temperature is saved.

To check the set switch-on temperature (start) or target temperature (stop), press the corresponding button once.

Switch-on temperature ^START lower than switch-off temperature ˇSTOP – HEATING MODE

Switch-on temperature ^START higher than switch-off temperature ˇSTOP – COOLING MODE.

Red wire: power supply (black – neutral).

Yellow wire: the device whose operation is to be controlled by the thermostat (black – neutral).

Name Details
Department Home and Garden
Category Smart Home
Producer Eurokomp
Colour Black
EUROKOMP BOGDAN SOBIERAŃSKI
Przecznica 51
59-630 Mirsk
PL
biuro@eurokomp.com.pl

Questions & Answers

There are no questions yet. Be the first :)