----------
Technical specifications
----------
Load capacity: up to 1 kg/3 cm2
Temperature resistance: 10 ~ 40°C
Elongation at break: 300%
Peel strength: 8.5~14.5 N/cm
Adhesion to materials: smooth and non-porous surfaces – marble, glass, tiles, metal, plastic, etc.
Material: PU gel
Thickness: 2 mm
Width: 30 mm
Length: 3 m
Weight: 210 g
Colour: transparent

----------
Key features
----------
Durable, washable and reusable tape
Resistant to changing weather conditions, ozone, moisture and immersion in water
Leaves no traces and does not damage surfaces
Wide range of applications

The tape is supplied with a plastic liner that must be removed before application.


INSTRUCTIONS:

1. Measure the required length of tape. Cut only one strip at a time.
2. Place the tape on the surface with the adhesive side facing down and press it firmly. Use a sufficient amount of tape (e.g. when hanging a picture, apply the tape to all sides of the frame).
3. Remove the backing to expose the other side of the tape.
4. Place it on the surface to which it is to be attached. IMPORTANT: Press the bonded area firmly for 15–30 seconds to ensure proper installation.
5. To remove the tape, pull at the edge.

For best results, clean both surfaces before application. When applying to glass or stainless steel surfaces, use glass cleaner. Make sure the surface is flat, dry, clean and free of grease.
When used on painted surfaces, the application will be permanent. Removing the tape may cause the paint to peel.
Tip: To remove the tape smoothly from a painted surface, spray water onto the edges of the tape to avoid damaging the surface.